New Page 1 Quality, wideband performance, and affordability are built in to this series of active and passive multicouplers, allowing multiple receivers to be used with one principle antenna

"I live 30 miles and two large mountain ridges from the San Diego 800MHz trunked system I want to monitor. My reception with an all band Discone was only 20% intelligible with anywhere from 10% to 70% trunking decoding accuracy. I bought a Stridsburg preamp and achieved an 85% intelligibility and most often a 98% decoding accuracy. I was amazed! This is a great product!"
S. Fulrath

Stridsberg Engineering
 Technical Notes & Applications

Unused ports may be left open (Unterminated) in most applications, such as in standard monitoring using scanners and other similar receivers. Terminating unused ports into 50 ohms is required when specification for isolation and gain balance (flatness) must be held within 2dB from port-to-port and over frequency range. In large receiver monitoring platforms this will be an important issue.

Only a "Passive Multicoupler" will support a signal combining function. The "Active" multicouplers can not be used in "reverse", i.e. as a signal combiner.

 

MCA104Asm.jpg Stridsberg MCA104 Active Multicoupler, 500 kHz - 50 MHz, 4 Ports CPL1 $184.95

Designed to distribute antenna signals to four receivers without loss and with high isolation between ports. It is specifically suited for signal intercept and HF monitoring stations, both fixed or mobile platforms. It can be used in any HF monitoring post using receivers, scanners or spectrum analyzers.

 
MCA104Asm.jpg Stridsberg MC104 Passive Multicoupler, 100 kHz - 500 MHz, 4 ports. CPL7 $94.95

Passive broad-band models are manufactured to meet a multitude of HF, VHF and UHF monitoring applications. Standard port configurations from 2 up to 8 are available. These units are designed to meet government and commercial radio monitoring demands as well as the general hobby market.

MCA108sm.jpg Stridsberg MCA108M Active Multicoupler, 100kHz-50MHz, 8 Ports CPL2 $334.95

New Page 1

MCA108M is an active multicoupler designed to distribute antenna signals to eight receivers without loss and with high isolation between ports. It is specifically suited for signal intercept and HF monitoring stations, both fixed or mobile platforms. It can be used in any HF monitoring post using receivers, scanners or spectrum analyzers.

phpQ6WdNnPM.jpg Stridsberg MC102 Passive Multicoupler, 100 kHz - 500 MHz, 2 ports. CPL06 $69.95

Passive broad-band models are manufactured to meet a multitude of HF, VHF and UHF monitoring applications. Standard port configurations from 2 up to 8 are available. These units are designed to meet government and commercial radio monitoring demands as well as the general hobby market.

MCA204Asm.jpg Stridsberg MCA204M Multicoupler VHF/UHF Receiver CPL3 $184.95

MCA204M is an active multicoupler designed to distribute antenna signals to four receivers without loss and with high isolation between ports. It is specifically suited for signal intercept stations, both fixed or mobile platforms. It can be used in any VHF/UHF monitoring post using receivers, scanners or spectrum analyzers.

NOW WITH!! Improved Dynamic Range, Front-end protected against transient pulses and nearby transmitter burn out.
php4RB4N6PM.jpg Stridsberg MC204 Passive Multicoupler, 10 MHz - 1 GHz, 4 ports. CPL9 $94.95

Passive broad-band models are manufactured to meet a multitude of HF, VHF and UHF monitoring applications. Standard port configurations from 2 up to 8 are available. These units are designed to meet government and commercial radio monitoring demands as well as the general hobby market.

phpqfP1EqPM.jpg Stridsberg MC202 Passive Multicoupler, 10 MHz - 1 GHz, 2 ports. CPL8 $69.95

Passive broad-band models are manufactured to meet a multitude of HF, VHF and UHF monitoring applications. Standard port configurations from 2 up to 8 are available. These units are designed to meet government and commercial radio monitoring demands as well as the general hobby market.

MCA208sm.jpg Stridsberg MCA208M Active Multicoupler, 25MHz-1GHz, 8 Ports. CPL4 $334.95

VHF

An active multicoupler designed to distribute antenna signals to eight receivers without loss and with high isolation between ports. It is specifically suited for signal intercept stations, both fixed or mobile platforms. It can be used in any VHF/UHF monitoring post using receivers, scanners or spectrum analyzers.

NOW WITH!! Improved Dynamic Range, Front-end protected against transient pulses and nearby transmitter burn out.
SPL02sm.jpg Full-Spectrum Antenna Splitter Set SPL02 $29.95

    Now you can run two receivers and/or scanners for continuous 500 kHz-1000 MHz medium wave, shortwave and VHF/UHF reception from one wide-frequency-coverage antenna!
SWC01sm.jpg DC-2 GHZ ANTENNA SWITCH SWC01 $19.95

Now you can select between two antennas for your receiver, scanner, or low-power transceiver--or you may choose either of two radios to connect to your antenna!